rig8 promo

The Hydrill 1000 is a multi purpose Diamond Coring and Wash Drill

Specifications

Manufacturer Almet Masters
Mounted Track Mounted
Deck Engine Caterpillar, 3056 159 hp, 24 volt start or hand start
Top Drive 2 speed (rack back feature), 1300 nm @ 650 rpm, 750 nm @ 1150 rpm
Drill Mast 6m rod pull capacity, Angles 45° - vertical
Pivot system to have mast set on ground
Main Winch Max pull 37,450 lbs single line, Max speed 120m/minute
Wire Line Capacity 1000m 6mm wire rope
Pull Back 40,300 lbs head
Diamond Coring Capacity NQ 1000m, HQ 800m, PQ 430m
Levelling Jacks Rear 4” 1.8m stroke, Front 4” 1.8m stroke
Fluid Pump Bean W1122, GPM 37, Max pressure 1000 psi
Flame Proof Spark arrestor on exhaust, Manual shut off on air intake, Manual start
Supported By 1x 4KVA genset
1x 150amp welder
1x 4x4 double cab ute
1x 6x4 Scania Hiab truck
1x 3.3m tandem trailer
BOP Equipment 1x HQ annular bag 600 psi
1x Guiberson wireline stripper 1500 psi
1x Well head mudcross to suit
1x HQ Kelly cock
1x Hydraulic manual pack to active annular & stripper
1x 6” master valve class 150 or 300
1x Gas detector
Pumps 1x GD 4 x 6 duplex, cement & mixing pump 500 psi @ 1.2 gps
1x Supply pump 130 l/min 40 bar mud hopper 600m poly
600m 32mm poly pipe
Drill Pipe 250m 4 ½” HWT, 800m 3 ½” HQ
1.5-3.0m 6m barrels
   
 
Go to top